
ELECTRICAL REQUIREMENTS AND GROUNDING INSTRUCTIONS
CAUTION - ALL MODELS
In Case of an Electrical Failure
If for any reason a gas control knob is turned ON and there is no electric power to operate the
electronic igniters on the cooktop burners, turn OFF the gas control knob and wait 5 min-
utes for the gas to dissipate before lighting the cooktop burner manually.
To light the cooktop burners and grill manually, carefully hold a lighted match to the burner ports
and turn the gas control knob to HI. During a power failure, you can manually light the standard
cooktop burners and grill only, but each must be lit with a match.
DO NOT attempt to light the two left burners manually. These burners are equipped with
the ExtraLow® feature and cannot be lit manually.
See Pages 11 and 29 for additional information on manually lighting the burners.
Section 1: GENERAL SAFETY INSTRUCTIONS
PLEASE READ CAREFULLY
All Cooktop models and the Wok require an electri-
cal circuit rated at 120 volts, 60 Hz., 10 Amps, ex-
cept models with electric griddle require 15 Amp cir-
cuits.
For personal safety, this appliance must be con-
nected to a properly grounded and polarized
electrical power supply.
Always disconnect the electrical plug from the wall
receptacle before servicing this unit.
See Installation Instructions for electrical
requirements and grounding instructions.
DO
NOT
UNDER
ANY
CIRCUMSTANCES
CUT
OR
REMOVE
THE
SEPARATE
GROUND
WIRE
OR
THE
THIRD
(GROUND)
PRONG
FROM
THE
POWER
CORD
PLUG.
It is the personal responsibility and obligation of you,
the user, to have this appliance connected to the
electrical power supply in accordance with the Na-
tional Electrical Code and/or applicable local codes
and ordinances by a qualified electrician.
It is recommended that a dedicated circuit servicing
this appliance be provided.
2
CAUTION
Safety Precautions
Comentarios a estos manuales